← All posts
Production

Spirality in Knitted Fabric: Causes and Checks

27 October 2026 · Kamna Team

Spirality is when the lines in a knitted fabric slant instead of running straight up and down. In a T-shirt it shows after washing: the side seams twist toward the front or the back. It happens mostly in single jersey, the fabric of most T-shirts. Rib and interlock fabrics rarely have it.

What do wale, course and feeder mean?

A wale runs up the fabric, a course runs across it, and a feeder puts yarn into the knitting machine. In more detail:

  • Wale: a line of loops running up and down the fabric.
  • Course: a row of loops running across the fabric.
  • Feeder: a point on a circular knitting machine where yarn goes in. Large machines have many.

In good fabric, wales and courses cross at a right angle. With spirality, the wales lean to one side.

What causes spirality?

Mostly the twist in the yarn, with the way the fabric is knitted adding to it. The main causes:

  • Twist in the yarn. Yarn is made by twisting fibres together, and twisted yarn tries to untwist. In single jersey this pulls every loop the same way. More twist means more pull.
  • Fine yarn. Finer yarn usually slants more.
  • Loose knitting. Long loops and soft, open fabric slant more than tight fabric.
  • Many feeders. On a circular machine, more feeders make the rows sit at a slope.
  • Machine direction. The way the machine turns and the way the yarn is twisted can add to each other.

How do you measure spirality on a T-shirt?

Wash one, then measure how far the side seam has moved. Step by step:

  1. Wash and dry a T-shirt made from the lot.
  2. Lay it flat without pulling it.
  3. Measure how far the bottom of the side seam has moved sideways.
  4. Divide that by the side seam length and multiply by 100.

Example: the seam moved 3 cm on a 50 cm side seam. 3 / 50 x 100 = 6% spirality.

How do you measure spirality on fabric?

Measure how far one wale leans over a set length. Step by step:

  1. Draw a line along one wale, at least 50 cm long.
  2. Lay the fabric flat without stretching it.
  3. Measure how far the wale has moved sideways over that length.

Example: 4 cm over 50 cm is a slant of about 4.6 degrees. Lab methods such as AATCC 179 and ISO 16322 measure the change after washing. Your buyer's specification sets the limit.

Can finishing fix spirality?

Only for a while. Relaxing, compacting and stentering pull the wales back in line, so the fabric looks straight on the table. But the twist is still in the yarn, so the slant often comes back after a few washes. Heat, steam and resin treatments have the same problem, and resin also weakens cotton. That is why the check is done on a washed sample, never on the roll as it arrives.

How do you prevent spirality?

Fix it at the yarn and the knitting machine, with the spinner and the knitter:

  • Use yarn with balanced twist, such as a two-ply yarn twisted to cancel the pull.
  • Steam or heat set the yarn before knitting, so it pulls less.
  • Knit a tighter fabric with shorter loops.
  • Run fewer feeders when the problem keeps coming back.

Spirality and fabric shrinkage both show up in the same wash, so one washed sample can answer both before the lot is cut.

Found this helpful? Add us to your preferred sources for more like it.

Kamna. Not an ERP. One thing: Profit Margin. Ask your factory and it answers.

For more content like this, join us here.