← All posts
Production

Fabric Shrinkage Formula and the Pattern Fix

27 October 2026 · Kamna Team

Fabric shrinkage is how much a fabric gets smaller after washing and drying. It is measured as a percentage, separately for length and width. A factory needs this number before cutting, so the garment still fits its size after the first wash.

What is the fabric shrinkage formula?

Shrinkage % = (size before washing - size after washing) / size before washing x 100.

Example: two marks are 50 cm apart along the length. After washing they are 47.5 cm apart.

  • Lost: 50 - 47.5 = 2.5 cm
  • Shrinkage: 2.5 / 50 x 100 = 5%

Do the same across the width. If 50 cm becomes 48.5 cm, the width shrinkage is 3%. Some lab reports write shrinkage as a minus number, such as -5%, so check which way a report counts before using it.

How do you test fabric for shrinkage?

Mark it, measure it, wash it, and measure it again. Step by step:

  1. Cut a piece of fabric away from the selvedge.
  2. Mark pairs of points in both directions at a known distance, for example 50 cm.
  3. Measure each distance and write it down.
  4. Wash and dry the piece the way the garment will be washed.
  5. Let it rest flat, then measure the marks again.
  6. Work out the length and width shrinkage with the formula.

Labs follow set methods, such as ISO 6330 with ISO 3759 and ISO 5077, or AATCC 135. Use the method your buyer names. A quick test on the floor still gives the cutting room an early answer before the lab report comes back.

How much bigger should the pattern be cut?

Divide the finished size by what is left after shrinkage. Divide, do not add. If fabric shrinks 5%, only 95% of each length is left after washing, so divide the size you want by 0.95.

Example for a body length of 70 cm:

  • At 5% shrinkage, cut 70 / 0.95 = 73.68 cm. Adding 5% gives only 73.5 cm, which washes down to 69.83 cm.
  • At 8% shrinkage, cut 70 / 0.92 = 76.09 cm. Adding 8% gives only 75.6 cm, which washes down to 69.55 cm, almost half a centimetre short.

Correct the width the same way, with the width figure. A bigger pattern uses more fabric, so work out fabric consumption from the corrected pattern.

Why does fabric shrink?

Because making the fabric stretches the yarn, and washing lets it relax. Knitting, weaving and finishing all pull on the yarn. Knitted fabric usually shrinks more than woven fabric. The same fabric can also shrink differently from one lot to the next, so every lot needs its own test.

How can a factory keep shrinkage low?

Buy fabric that has already been shrunk, and test every lot. In practice:

  • Woven cotton: ask for sanforized fabric. Sanforizing presses the fabric between a rubber blanket and a heated drum, so it shrinks before cutting instead of after.
  • Knitted fabric: ask for compacted fabric. Compacting shortens and narrows the fabric for the same reason.
  • Ask the processor for the shrinkage of every lot, and test it yourself.
  • Follow the shrinkage limit in your buyer's specification. It differs by fabric and garment.

Side seams that twist after washing are a different fault, called spirality. Check for it in the same wash.

Found this helpful? Add us to your preferred sources for more like it.

Kamna. Not an ERP. One thing: Profit Margin. Ask your factory and it answers.

For more content like this, join us here.